creating footpring according to rf connector datasheet 32K243-40ML5

Y

yefj

Advanced Member level 5
Joined
Sep 12, 2019
Messages
1,505
Helped
1
Reputation
2
Reaction score
5
Trophy points
38
Activity points
9,113
Hello,I need to create three pads to accomidate the RF conector.
two pads fro the crews and one pad for the inner RF pin.
few questions.
1. how can I know to which board width this component can handle?
2.according to the datasheet what is the inner pin pad width and length I should use?
3.I want the crews to be in tight fit so the connector woulg be stable in the board.
What pad diameter I should use?
Thanks.
https://products.rosenberger.com/_ocassets/db/32K243-40ML5.pdf
 

Sort by date Sort by votes
Manufacturer is proving a footprint drawing https://products.rosenberger.com/_ocassets/mb/MB_208.pdf

PCB design with correct transmission line transition, topology and impedance is however your job.

I remember that you have asked about mounting of similar connectors in previous threads. While Rosenberger seems to offer only a single connector of this type, other manufacturers have a larger portfolio, probably fitting a larger range of PCB configurations. I believe they also provided more detailed mounting instructions.
 

Upvote 0 Downvote
You can use a pad diameter matching the screw size, such as 2 mm for the plated hole and 2.85 mm for the clearance hole.
 

Upvote 0 Downvote
You must log in or register to reply here.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…