relax4567
Newbie level 3
- Joined
- May 10, 2011
- Messages
- 3
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Activity points
- 1,299
Hi
I am drawing the layout of my circuit using Virtuoso. I am using create path command to connect different blocks.
By mistake I pressed some key. Now, when I draw a path it shows the DRC rules ( like minimum metal width, minimum spacing) which makes the layout drawing easier.
I tried to figure out how I should setup the Virtuoso to do this but I could not.
I rally appreciate if someone can help me with this.
Thanks
I am drawing the layout of my circuit using Virtuoso. I am using create path command to connect different blocks.
By mistake I pressed some key. Now, when I draw a path it shows the DRC rules ( like minimum metal width, minimum spacing) which makes the layout drawing easier.
I tried to figure out how I should setup the Virtuoso to do this but I could not.
I rally appreciate if someone can help me with this.
Thanks