Create layout directly in Allegro PCB SI

Hello,

Is it possible to create layout directly in Allegro PCB tool (without having a deal with schematic):

• create list of nets
• create geometry objects
• associate these objects with nets
• create stackup
• associate particular net with a stackup layer

Thanks in advance

Pavel

Hi
you can keep the footprint and you can assign the net but it is not right method.
for assign net manually for footprints use this link

if you are using allegro please use this link
https://community.cadence.com/cadence_technology_forums/f/27/t/23175

which tool r u using better follow the design flow it will help for tracking in critical conditions

Yes but only if you are daft, the whole point of a schematic (circuit diagram) is to have a guide to the electronics, not only that but you are likely to add errors and updates will be impossible.
WHY do something the way we had to in the late 80's, it nearly 30 years since I didn't use a schematic capture package to enter the circuit diagram!

Pavel47, all schematic/layout packages will let you make a PCB without a schematic and many people use them this way for simple pcb's.

Simple PCB or not it is a rather silly way to work (and not many work that way, and those that do are DIYers), you have to have some form of schematic for your design, be it on paper or electronic, so you might as well enter the schematic electronically and get all the benefits and avoid the numerous pitfalls of adding connections within the PCB package or manually translating the schematic to a net list.

marce said:

Simple PCB or not it is a rather silly way to work (and not many work that way, and those that do are DIYers), you have to have some form of schematic for your design, be it on paper or electronic, so you might as well enter the schematic electronically and get all the benefits and avoid the numerous pitfalls of adding connections within the PCB package or manually translating the schematic to a net list.

Click to expand...

Hi Marce,

Thank you for feedback. The reason to use layout tool without schematic is to simulate a particcular structure from the elctromagnetic point of view: calculate mutual capacitance between conductors, or even better - extract spice model of structure in form of RC-matrix and then use it in circuit simulation.

The final goal is to simulate strcuture in Sigrity PowerSI 3D EM Full-Wave, but it seems that this tool can only import layouts.
So I see the flow in the following way:

• create structure in PCB Editor
• import it in Sigrity PowerSI
• simulate strcuture using Sigrity 3D EM Full-Wave simulator
• extract model spice in form of RC-matrix
• use this model in overall circuit simulation

I would be grateful for any comments concerning this flow

Regards

Pavel

I use Si software and it is the same, you have to import a physical layout, but we do generate this from a schematic... Again it is the quickest and most error free way to do this.
What I can do is create scenarios in my SI tool, where I can pick a receiver and transmitter and then add transmission lines etc between them, but my tool is Cadstar SIV .

marce said:

I use Si software and it is the same, you have to import a physical layout, but we do generate this from a schematic... Again it is the quickest and most error free way to do this.
What I can do is create scenarios in my SI tool, where I can pick a receiver and transmitter and then add transmission lines etc between them, but my tool is Cadstar SIV .

Click to expand...

Hello Marce,

Is your tool capable to simulate the structure like this (please, see the picture)
there are 2 layers of conductors - dimond-like shapes and 2 ... 5 layers of dielectrics.
There is no schematic for such structure ... at least it isn't necessary at all ... ok I could deliberately create some schematic if layout tool does requires it ...
I've just tried with PowerSI and found a bizarrerie: tool doesn't allow to create shapes of signal-type layer ... only on plan layer.
Is Cadstar more flexible in this sens ?

Regards