Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Conformal lec question

Status
Not open for further replies.
S

skyworld_cy

Junior Member level 3
Junior Member level 3
Joined
Jun 29, 2011
Messages
31
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,288
Activity points
1,513
Hi,
when I run conformal LEC, I met a problem. After "compare" command, I tried to debug my non-eq cells. I tried to run "invert mapped points", but the GUI responds with "Mapping phase cannot be inverted". This confused me. I have tried to set "invert mapped points" in setup mode, before/after mapping process, all failed. Can anybody help me? thanks
 

The Non-eq is caused by incorrectly mapped key point? It might be caused by some other reason.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top