engineer1000
Advanced Member level 4
- Joined
- Aug 16, 2012
- Messages
- 106
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,296
- Activity points
- 2,060
Does anyone know anything about these IGBT driver modules?
I have one set up in half bridge mode. I have INB pulled to 5V and INA a 30khz square wave.
The two fault outputs are pulled hi via 2 10k resistors. So the module thinks that there is no fault. But in this state I can't get the gate outptus to switch one sits at a -ve voltage the other at about 0V . So I don't know why the module will not switch.
Can anyone help?
I have one set up in half bridge mode. I have INB pulled to 5V and INA a 30khz square wave.
The two fault outputs are pulled hi via 2 10k resistors. So the module thinks that there is no fault. But in this state I can't get the gate outptus to switch one sits at a -ve voltage the other at about 0V . So I don't know why the module will not switch.
Can anyone help?