comparator in proteus

Status
Not open for further replies.
M

mshh

Full Member level 6
Joined
May 30, 2010
Messages
349
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Location
usa
Visit site
Activity points
3,871
i used lm339 comparator with the attached circuit .i want to drive Mosfet but the output in simulation is 2.2 v on the pin1 of the comparator .however it should be Vsat. when i decreased R1 to 10 ohm the output on led increased to 5.1 v .what is the problem . i want to get 11 v from this circuit at least and that will only happened if i put R1 = 0.

Is there any simpler circuit than this one?

 
Last edited by a moderator:

R9 should be 100R at least not 10R, the max current sink is 18mA.
 

HTML: 
R9 should be 100R at least not 10R, the max current sink is 18mA.

Sorry I made a mistake and for some reason I am unable to edit my post. R9 should be 1K not 10R.
 

i told you it was 1K and he output on the led was 2.2 V however it should be Vsat.at least 10 v to run the mosfet.
 

The output will only be 2.2V or so because of the LED forward voltage drop!!!
 

what is your Vref voltage ? and why use comparator for driving the mosfet? I mean comparator output would be zero when Vin reached to Vref or greater then Vref.for less then Vref it should be output 14 or 15 v if your supply is 15v.

 

Attachments

  • comparator.jpg
    374.8 KB · Views: 537

the problem was the led . the output was the voltage drop 2.2 i didn't know that this voltage was the voltage drop . when i replaced it with mosfet the output was 15 v .Is there any problem to use comparator to drive mosfet ? vin is 0-10 v it is also a ramp . Vref will be ramp also but with different frequency .
thanks
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…