Communicating to a device via Bluetooth in Labview

Status
Not open for further replies.
G

Girly_girl

Full Member level 2
Joined
Oct 14, 2009
Messages
143
Helped
9
Reputation
18
Reaction score
8
Trophy points
1,298
Location
UK
Visit site
Activity points
2,125
Hi all,

has any one tried Communicating to a device via Bluetooth in Labview?
If so what are the approach? any .vi that I could start with?

Thank you
 

You can just build simple Serial communication vi for communication with your device ..Its given in the examples also. I used some time ago.

You need to check your device bluetooth baurd rate and set same in LABVIEW Serial communication module...

https://www.ni.com/example/27669/en/

download the attachment vi on the right hand side at given on above link
 
Hi Thank you so much for your reply - do you have any idea on how I could check the baude rate of the bluetooth device? Its a Unique cfm device for collecting EEG signals
 

you can look in your Bluetooth hardware manual basically Bluetooth works on two modes command mode and data mode you can enter in command mode and see the configuration of your Bluetooth. I don't know about your Bluetooth mac but I can give you link for my Bluetooth user manual.

https://www.sparkfun.com/datasheets/Wireless/Bluetooth/rn-bluetooth-um.pdf

But Please do refer your device user manual ...
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…