dperez79
Member level 1
iec 870-5-104
Dear all,
I am receiving after a set-point command ( C_SC_NA_1 in IEC 870-5-104 protocol ) two confirmation messages with differents COTs (Cause of Transmission):
1- COT=7 -> Activation confirmation
2- COT=10 -> Activation termination.
And then these set points commands are not controlling the remote.
What does this COT=10 (Activation termination) means?
Why are we receveing this second confirmation messsage?
A lot of thanks,
Daniel P.
Dear all,
I am receiving after a set-point command ( C_SC_NA_1 in IEC 870-5-104 protocol ) two confirmation messages with differents COTs (Cause of Transmission):
1- COT=7 -> Activation confirmation
2- COT=10 -> Activation termination.
And then these set points commands are not controlling the remote.
What does this COT=10 (Activation termination) means?
Why are we receveing this second confirmation messsage?
A lot of thanks,
Daniel P.