code C for conncetion of gyrocompas in FPGA

didaSET · Feb 24, 2015

how to add i2c on MicroBlaze EDK

hello
I need your help I want to connect a gyrocompas(HMC5883L) with a microblaze which is done by I2c and as microblaze does not have the bus I2c. I must add it as a peripheral to the microblaze but I do not know how in EDK
regards

dpaul · Feb 24, 2015

Re: how to add i2c on MicroBlaze EDK

In case your your gyrocompas(HMC5883L) has a I2C and the microblaze does not, then you need to do a bus protocol conversion. A traditional way to do this is to use a protocol conversion bridge. So if your microblaze is using ABC protocol, then you need to design a ABC-to-I2C bridge and add it to the Microblaze.

ads-ee · Feb 24, 2015

Re: how to add i2c on MicroBlaze EDK

Tutorial on adding a custom IP to EDK.
**broken link removed**

It's definitely dated as the current MicroBlaze default bus protocol is AXI4 in ISE 14.7.

You can also look at Xilinx document UG682: https://www.xilinx.com/support/documentation/sw_manuals/xilinx14_7/edk_ctt.pdf
Take a look at Chapter 6 on page 45.

didaSET · Feb 24, 2015

Re: how to add i2c on MicroBlaze EDK

I'll see it thank you

didaSET · Mar 7, 2015

hello
Someone has already work on the code for the conncetion of gyrocompass HMC5883L with MicroBlaze in 3AN FPGA

code C for conncetion of gyrocompas in FPGA

didaSET

Newbie level 3

dpaul

Advanced Member level 5

didaSET

ads-ee

Super Moderator

didaSET

didaSET

Newbie level 3

didaSET

Newbie level 3

Similar threads

code C for conncetion of gyrocompas in FPGA

didaSET

Newbie level 3

dpaul

Advanced Member level 5

ads-ee

Super Moderator

didaSET

Newbie level 3

didaSET

Newbie level 3

Similar threads

Privacy & Transparency

Privacy & Transparency