Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CO thermometer on the LCD 4x12

Status
Not open for further replies.
V

Vermes

Advanced Member level 4
Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


It is a project of a thermometer to measure temperature of water on the stove and boiler.
The device is based on Atmega8 microcontroller, the display applied has RGB backlight. Control of illumination in green is achieved by Adc photoresistor and Atmega PWM (when it is bright in the room, it dims the display). Red light is used together with the buzzer when the temperature exceeds 88 degrees Celsius. Temperature sensors are DS18B20.
The program was written for CO installation, but it can be improved to measure water heated by the solar.
The program was written in Bascom. The buttons are used for mode Co and Solar switching.



Link to original thread (useful attachment) – Termometr CO na LCD 4x12
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top