Co-simulation of extracted and shematic view.

Status
Not open for further replies.
J

jjang

Newbie level 1
Joined
Mar 11, 2003
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
10
Hello all,
I have a question about co-simulation of extracted view and schematic view. My question can be very dumb, but if you know anyting about this issue, let me know.

My situation is this. I draw a schematic and it is a componet of higher schematic. I also did layout. After that, I run extracter and got the extracted view.

What I want is running spectre simulation with that extracted view and the general schematic view AT THE SAME TIME.

In my opinion, Cadence might support this functionality.

Thanks,
Jinwook
 

Use the config view to select the extracted view instance to be simulated with an extracted netlist and the other with the schematic netlist. The config view defines which instance or cell should be netlisted from which view.
 

If you mean use the schematic view for the top cell while extracted view for the sub-cells, you may just put the 'extracted' before 'schematic' in stopViewList. The extracted should have the same pin definitions as the schematic and symbol view.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…