Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
usually EM designers says that there is no one standard diameter, They says that only the design specifications (cut-off, group delay etc) sets the dimension.
I agree, but for my knowledge, some standards exist even if they are very free. The dimensions has been proposed many years ago form Millitech, Hughes and TRG.
At present Millitech still exist.
Hughes and TRG has been sold , at present days, look for Quinstar or Wisewave **broken link removed** http://www.quinstar.com/ http://www.millitech.com/
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
