circuit component's value with 6 volts in place of 12 volts

Status
Not open for further replies.

rajaram04

Advanced Member level 3
Joined
Jun 17, 2012
Messages
871
Helped
6
Reputation
12
Reaction score
5
Trophy points
1,298
Location
earth
Visit site
Activity points
7,687
Hello sir

i got a circuit diagram related to battery protection against over discharging



But the above diagram is configured as per 12 volts but i need to design it with 6 volts so please help me to redesign it with proper component values . . . thanks
 

You'll need a sensitive relay which works on 5 V or so.

There may be a point where it is more efficient to dispense with the relay and instead power the load from a comparator (or op amp).
 

BradtheRad said:
You'll need a sensitive relay which works on 5 V or so.

There may be a point where it is more efficient to dispense with the relay and instead power the load from a comparator (or op amp).
Click to expand...



but its difficult to get one , well what about other components ?? Is there any change we need ?
 

The reason for ZD1 (zener diode) and the TL431, is to prevent the coil from getting overmuch current. You adjust the TL 431 until you get your desired range of operation.

However since your system is 6V, ZD1 could be unnecessary. Or else you can change it to a diode pointing downward. This will drop 0.6 V, and the TL431 will not need to dissipate as much power.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…