Choosing capacitor type

Status
Not open for further replies.

Pha5e

Advanced Member level 4
Joined
Dec 9, 2011
Messages
102
Helped
7
Reputation
14
Reaction score
6
Trophy points
1,298
Location
I am not here - it's an illusion
Visit site
Activity points
1,938
Hello,

I am a little confused on the type of capacitor to use in a precision Op-Amp transimpedance amplifier circuit.

As I understand, electrolytics are generally for supply decoupling and ceramics are used to supress high frequency noise.

What type should I use in the Op-Amp circuit to maintain measurement precision?

Thanks.
 

Among the more common types:

Good: Polystyrene or Polypropylene
OK: Polyester / Mylar
Bad: Ceramic, Tantalum and aluminum electrolytic.

Exception: NPO ceramic caps are good, but look the same as normal ceramic caps, which are lousy.
 
Reactions: Pha5e

    Pha5e

    Points: 2
    Helpful Answer Positive Rating
Thanks for your reply Godfrey.

I just did some reading on NPO capacitors and it seems they are highly stable even with temperature fluctuations. The only factor is the size of them.

What are silver mica capacitors like for stability/precision?
 

Pha5e said:
What are silver mica capacitors like for stability/precision?
Click to expand...
I wish I had a clue, but I don't. :sad: I used to be under the impression they were good. Then I saw a couple of rude comments about them in another forum. Now I'm not so sure. Frustrating since I have no idea if there was any validity to the criticism or not.

As previously mentioned, I'd recommend Polystyrene or Polypropylene. Apparently Teflon caps are very good too, but not very common AFAIK.

Pha5e said:
...highly stable even with temperature fluctuations.
Click to expand...
Other things to worry about are dielectric absorption and non-linearity. Some graphs I've seen of capacitance vs applied DC voltage for ceramic caps are quite horrifying - e.g. a change in capacitance by a factor of about 2 to 1 within the specified voltage range.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…