Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Choice of Pic or TI for frequency measurement

Status
Not open for further replies.
P

pnielsen

Member level 2
Member level 2
Joined
Mar 18, 2002
Messages
50
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
319
Pic or TI

I need 5 outputs and one frequency input. Max frequency is 20Khz. Serial communication needed or Parrallel. This will be multiplied by 11. Total frequences to measure is 33. Looking at one pic per sensor. Each sensor has three frequncys. Any suggestions. Looking at Microchip and MSP430

Thank you :!:
 

HI,

In my experience, the MSP430 it's more cheaper but have less development tools. I use Proteu.s, and with it I avoid the breadboards (in almost cases), because of this I should use PIC ... (MSP is not suported)

NeuralC
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top