Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Charge Battery With PC Power Supply

Status
Not open for further replies.

ksnl2008

Newbie level 5
Newbie level 5
Joined
Mar 29, 2008
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,332
Hello everyone,
I have an old PC Power Supply. Is there any idea to charge 12V 110Amp Led-Acid Battery with this Power supply?

I shell be very thankful to you for that
 

Not without major reconstruction.
To charge 12V/110Ah battery you need 14V(and a little bit more) and at least 10A.
DrWho :D
 

Apart from needing 14 - 14.5 V output, the SMPS must also be able to deliver constant current, it must have a current limiter rather than a overcurrent shutdown. Some SMPS can, some can't. A PC powersupply probably hasn't a usable constant current mode. The SMPS must also allow increasing the output voltage, e. g. by an adjustment potentiometer. A lot of industrial single voltage SMPS can be used as a battery charger, but it must be checked with datasheet first, if it's possible at all and also if this operation is allowed permanently by design, and then verified empirically.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top