[SOLVED] Characteristic Impedance (getting Z0) simulation in HFSS using Lumped ports ?

Status
Not open for further replies.
R

rdpdo2002

Member level 1
Joined
Oct 28, 2020
Messages
32
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
123
Hello,

I am able to get Z0 of a microstrip transmision line using modal wave ports but if I want to use lumped port I am stuck because I need to enforce the impedance to some value. So the Z0 is this value, but not the real value...

Is it possible to get Z0 of a tansmision line using lumped ports ?

Thanks you !
 

Sort by date Sort by votes
rdpdo2002 said:
Is it possible to get Z0 of a tansmision line using lumped ports ?
Click to expand...
If you simulate a line length of some wavelenths, the input impedance (from S11) will run in circles around the value of Zline. So you can calculate that center value from input impedance.

(This assumes that there are no parasitics from the lumped ports.)
 

    R

    rdpdo2002

    Points: 2
    Helpful Answer Positive Rating
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…