Changing the Power voltage of the CHIPS in PROTEUS

Status
Not open for further replies.
E

epilot

Member level 2
Joined
May 2, 2006
Messages
46
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,642
Hi folks.

Sorry, BUt How can I change the default values for th voltages of a Chip?
For instance I am using a TL072 OP-AMP in Proteus but The default voltage for it seem to be 5V even when I connect the higher voltages to pins #8 and 4 of the said chip.

Or for some other chips There in no voltage pin connected to the chip so that I could connect it to a voltage and seem to work by the default voltage, SO how to to solve the problem for such Chips?

Thank a bunch
 

in devices that have the supply pin you can use a DC power source and just set the value you want


When the supply pins are hidden then there is a power net assigned to them, you can assign a different net if you want using the following


The design power rails are shown in design -> configure power rails menu, you can add your own there
open the hidden pin of your device and connect the pin VCC to your selected net name, for example


then open the power rail , create a new power source , for example VCC_33 and set the voltage to 3.3v, then add the net that your component is connected to (in my case 33V_NET) to the created power source and you are done


Alex
 
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…