[CASE STUDY] Triggering Webcam REAL TIME such as in industrial applications ?

Status
Not open for further replies.

andre_luis

Super Moderator
Staff member
Joined
Nov 7, 2006
Messages
9,643
Helped
1,191
Reputation
2,401
Reaction score
1,218
Trophy points
1,403
Location
Brazil
Activity points
55,938
Hi friends,


I´m considering develop a very cheap System, based on any low cost embbeeded ARM11/CORTEX-A8 board ( Raspberry, PCduino, etc...).
In past, I used an USD~1,50 CMOS Webcam in other project, taking extremely good performance results regarding image quality.

However, I don´t know if there are some issues concernig maximum capture rate or other points.
( Image capture will be triggered electrically by uC, directly at Button terminals )

Anybody could share any advice about this approach ?

**broken link removed**

+++
 
Last edited:

I would ask the manufacturer to provide/sell the protocol or video/image frame format so I can process it on an embedded system without V/In. it is like implementing an IP camera.
 

Hi ausrasul,


Regarding image capture, I prefer if done electrically, due ( I suppose ) is processed by Webcam chipset with higher priority that some protocol command. Moreover, even if done by protocol, I´m considering to use solely standard Webcams, so that the project will not be tied to some brand manufacturer.


+++
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…