sunny656
Member level 1
verilogsimbinary is invalid
Dear RF_Router,
I cannot start the Verilog_XL to perform circuit simulation from the Schematic View of IC 5.0 after initializing IC 5.0 by typing and excuting icfb & at the linux prompt because of the following errors encountered during excution process:
1) "Invalid Verilog executable verilog
Please check existence and / or permission and try again.
Relative pathname are relative to run directory"
2)."User-settable global variable: verilogSimBinary is invalid
Relative pathnames are realtive to run directory
OK/CANCEL abort simulation"
The icons on the left side of Verilog_XL panel are found to be grayed out. I've verified that I have the write permission to the run directory as pointed by the relative path.
Please advise how to fix the problems.
Thanks.
Sunny656
Dear RF_Router,
I cannot start the Verilog_XL to perform circuit simulation from the Schematic View of IC 5.0 after initializing IC 5.0 by typing and excuting icfb & at the linux prompt because of the following errors encountered during excution process:
1) "Invalid Verilog executable verilog
Please check existence and / or permission and try again.
Relative pathname are relative to run directory"
2)."User-settable global variable: verilogSimBinary is invalid
Relative pathnames are realtive to run directory
OK/CANCEL abort simulation"
The icons on the left side of Verilog_XL panel are found to be grayed out. I've verified that I have the write permission to the run directory as pointed by the relative path.
Please advise how to fix the problems.
Thanks.
Sunny656
