Can't access boot block when programming a Winbond w49foo24 EEPROM

Status
Not open for further replies.
J

Joaquim

Member level 1
Joined
Jan 22, 2004
Messages
35
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
312
Hi
I´m trying to programming a winbond w49f002u eeprom with a universal programmer xeltek superpro III.
When i connect the device gives a id correct. when i try to load the programm it´s stop at address 3C000 it means that i can´t access to boot block because is protected
Can someone help me and to tell how can i erase and programm address between EC000 and 3FFFF ?
tx for replay
 

Re: programm w49foo24

I'm not so sure about this solution, but you might want to try to do a hot-swapping using an old PC (x86) mainboard for that. Some times I use this approach to fill flashrom with intended binary. Note that you can try a BIOS flashing program called uniflash fro this (www.uniflash.org/).
 

Re: programm w49foo24

hi
i´ve solved my problem tx to Pinczakko In the uf140.zip there is uniflash.txt.
After read those informations i connected 12v on pin 1 and it´s allow to flash the chip adress 3C000 to 3FFFF where it have write protected
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…