Actually - THAT is a normal meter, not the type with claws!
Connect it like this:
1. Turn everything electrical in the car off.
2. turn the switch to the 10A DC position (opposite the off position)
3. black plug goes to the COM hole
4. red plug goes to the 'A' hole (on the right)
5. Now the tricky parts: connect the black probe to the chassis of the car but NOT at the negative terminal of the battery, the far (engine or body) end of the wire to the battery negative is OK.
6. WHILE HOLDING THE RED PROBE ON THE BATTERY NEGATIVE POST, slacken and remove the clamp on the negative post. Take care to keep the red probe touching the battery at all times.
The meter will now read the current being drawn while the car is idle. A reading of less the 0.1A is a good sign, ignore whether it says + or -. There will always be some current flowing if the car has remote locking, a clock or an alarm system as these all consume power. Without removing the meter probe, get someone to turn the radio on and you should see a slight increase in current to confirm you are measurng correctly.
7. when finished, refit the clamp on the negative battery post before removing the red probe.
The reason for keeping the probe in place is to ensure the battery voltage is never completely removed. I don't know what car you have but on many, if the voltage drops to zero because the battery connection is broken, the security code for the radio and door locking may be lost and you will find it immobilized until reset by the manufacturers garage!
Under no circumstances attempt to turn the lights on or start the engine while the meter is connected, the current will be far too high for and damage will occur.
Brian.