Mr smile
Newbie
![Newbie level 3](/styles/images/ranks/alevel3.gif)
Hi Folks,
We are using dspic33ck128mp505 microcontroller. Then I configure CAN 2.0 and communicate with our controller. I have done for the CAN 2.0 Configuration for clock, nominal bit rate, interrupt, FIFO settings(TX , RX) and filter.
But data received from Mcu wrongly.
Then I attached the image for your reference. If I made a any mistake correct me.
Thanks & Regards,
MR SMILE.
We are using dspic33ck128mp505 microcontroller. Then I configure CAN 2.0 and communicate with our controller. I have done for the CAN 2.0 Configuration for clock, nominal bit rate, interrupt, FIFO settings(TX , RX) and filter.
But data received from Mcu wrongly.
Then I attached the image for your reference. If I made a any mistake correct me.
Thanks & Regards,
MR SMILE.