Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Calibre LVS needs to know the power net- Why?

Status
Not open for further replies.
E

ebuddy

Full Member level 3
Full Member level 3
Joined
May 15, 2007
Messages
177
Helped
35
Reputation
70
Reaction score
34
Trophy points
1,308
Activity points
2,372
Hi,

When calibre does the LVS, it needs to know where the VDD/GND nets are. I don't understand the reason why? Intuitively, power nets are not different from any other nets when it comes to LVS, or aren't they?
 

ebuddy said:
Hi,

When calibre does the LVS, it needs to know where the VDD/GND nets are. I don't understand the reason why? Intuitively, power nets are not different from any other nets when it comes to LVS, or aren't they?
Click to expand...

I think calibre only creats warning if there is no power/ground net. LVS can pass the comparison.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top