Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

cadence wavescan display problem

Status
Not open for further replies.
W

wpchan05

Full Member level 4
Full Member level 4
Joined
Feb 16, 2006
Messages
213
Helped
20
Reputation
40
Reaction score
4
Trophy points
1,298
Activity points
2,392
cadence wavescan

When I run an ac simulation in cadence ic5141, the wavescan viewer will display the frequency axis into the following (if log scale is enabled):
10^0 10^1 10^2 10^2 10^4 10^5 10^5 ...
However, the value as shown in the curve tracer indicates correct frequency values. Any idea on how to fix it?
 

wavescan cadence

i got the same problem and i think it`s a bug.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top