kingswan
Newbie level 4
Dear Everyone
I am trying to observe some output curve by Wavescan. When I use trace cursor, try to get the value of the curve, the coordinate on the left bottom cannot display normally (messy code). I use SSH and WIN32 to connect to the server to use Cadence. I suspected the problem was the resolution of my notebook's display, and I try to change the resolution, but it didn't work.
Could you please help me to solve this problems?
Thank you very much !
With best regards
KingsWan
I am trying to observe some output curve by Wavescan. When I use trace cursor, try to get the value of the curve, the coordinate on the left bottom cannot display normally (messy code). I use SSH and WIN32 to connect to the server to use Cadence. I suspected the problem was the resolution of my notebook's display, and I try to change the resolution, but it didn't work.
Could you please help me to solve this problems?
Thank you very much !
With best regards
KingsWan