Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Cadence Wavescan Coordinate of trace cursor display problems

Status
Not open for further replies.
K

kingswan

Newbie level 4
Newbie level 4
Joined
Nov 27, 2012
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,319
Dear Everyone

I am trying to observe some output curve by Wavescan. When I use trace cursor, try to get the value of the curve, the coordinate on the left bottom cannot display normally (messy code). I use SSH and WIN32 to connect to the server to use Cadence. I suspected the problem was the resolution of my notebook's display, and I try to change the resolution, but it didn't work.

Could you please help me to solve this problems?

Thank you very much !

With best regards

KingsWan
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top