Cadence SKILL - DC simulation homotopy order

Status
Not open for further replies.
T

t4_v

Full Member level 2
Joined
Jun 6, 2015
Messages
122
Helped
27
Reputation
54
Reaction score
28
Trophy points
28
Activity points
813
Hi,

I have a following issue: I would like to set homotopy order in a dc simulation using OCEAN script. I found in manuals that:

You can specify methods and their orders by specifying a vector setting such as homotopy=[source ptran gmin].
Possible values are none, gmin, source, dptran, ptran, arclength, tranrampup, and all.
Click to expand...

In OCEAN script I can run DC simulation with a homotopy method as follows:

analysis('dc ?dev "/voltage_dc_source" ?param "dc" ?start "low" ?stop "high" ?step "1m" ?homotopy "dptran" )


However, is it possible to define more than one homotopy value? I cannot find any scenario that works.
 

You probably already tried such syntax versions for the continuation methods:

 

I think I tried one or two of the above. So not all of them. I will check them tomorrow and give a feedback.

I used ADE L GUI to see how homotopy is chosen there. It is possible to choose only one method.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…