A_Coll49
Newbie
Hello,
I am trying to use AWR to extract an equivalent circuit model from S-parameter measurements I made on MIM capacitors. The method would be to build an equivalent circuit model of the MIM capacitor in the AWR schematic, designate component values as optimisation variables, and allow the optimiser to adjust these values until all 2-port S-parameters of the equivalent circuit model match the Touchstone .s2p file imported to the project. However, unlike ADS, it seems that you cannot compare two measurements in the optimiser, only compare a measurement with a fixed numerical variable. Is there another method I could use instead to get optimisation working? Any advice is greatly appreciated.
I am trying to use AWR to extract an equivalent circuit model from S-parameter measurements I made on MIM capacitors. The method would be to build an equivalent circuit model of the MIM capacitor in the AWR schematic, designate component values as optimisation variables, and allow the optimiser to adjust these values until all 2-port S-parameters of the equivalent circuit model match the Touchstone .s2p file imported to the project. However, unlike ADS, it seems that you cannot compare two measurements in the optimiser, only compare a measurement with a fixed numerical variable. Is there another method I could use instead to get optimisation working? Any advice is greatly appreciated.