Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Cad.... "Corners Analysis" setting problem

Status
Not open for further replies.
W

wccheng

Full Member level 5
Full Member level 5
Joined
May 16, 2004
Messages
287
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,296
Activity points
2,710
Dear all,

I have tried to use corners analysis windows to do the corner simulation. If I do the pss + pnoise simulation, it could not run pnoise after finished the pss. However, it doesn't prompt out any error or warning in the log file. Could anyone tell me why? I have tried to simulate pss+pxf. It is no problem. I am using 5141.

thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top