C++ code for SPI communication between ATMega 644A & ATMega328

Javaid1 · Jul 17, 2011

I want to communicate these two micro controllers (ATMega 644A & ATMega328) vis SPI protocol.
My goal is to introduce a routine in the ATMega 644A (Master) so that it will know and can respond to the ATMega328 (Slave).
Can somebody help me with this !!!

nandhu015 · Jul 17, 2011

What are you waiting for??

Go ahead do it..

bigdogguru · Jul 17, 2011

Here's an example simulation of a similar project:

An appnote detailing such an implementation:

This application note describes how to setup and use the on-chip Serial Peripheral
Interface (SPI) of the AVR micro-controller. Most AVR devices come with an on board
SPI and can be configured according to this document. After a theoretical background
it will be shown how to configure the SPI to run in both master mode and slave mode

**broken link removed**

The Serial Peripheral Interface (SPI) allows high-speed synchronous data transfer between an AVR device and peripheral devices or between several AVR devices. The strength of the SPI bus includes ease of use, high communication speed and a vast amount of peripheral devices supporting it.

**broken link removed**

Hope the info helps in your endeavors.

C++ code for SPI communication between ATMega 644A & ATMega328

Javaid1

Newbie level 6

nandhu015

Advanced Member level 5

bigdogguru

Administrator

Javaid1

Similar threads

C++ code for SPI communication between ATMega 644A & ATMega328

Javaid1

Newbie level 6

nandhu015

Advanced Member level 5

bigdogguru

Administrator

Similar threads

Privacy & Transparency

Privacy & Transparency