yefj
Advanced Member level 4
Hello, ther is an amplifyer which has a very uniques biasing network describes below in the datasheet and gerber file attached.
I want to power 4 such amplifyer in parralel.I have an RF dividing network which is two layers PCB.
I dont have a realistic model of the amplifier. I only have gerbers , the BOM the datasheet and i need to design network which would bias 4 such amplifies is parraelel.
also this amplifier sits on 10mm copper heat sink as shown below.
Is it possible?
If yes i would like to know how practically to do i make this big network which whould feed all four amplifiers simultniosly.
Thanks.
I want to power 4 such amplifyer in parralel.I have an RF dividing network which is two layers PCB.
I dont have a realistic model of the amplifier. I only have gerbers , the BOM the datasheet and i need to design network which would bias 4 such amplifies is parraelel.
also this amplifier sits on 10mm copper heat sink as shown below.
Is it possible?
If yes i would like to know how practically to do i make this big network which whould feed all four amplifiers simultniosly.
Thanks.