BSIM3v3 180nm Process

Status
Not open for further replies.
F

FARRUKHKHAN

Newbie level 5
Joined
Jan 14, 2015
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
66
what is the value of Vdd for BSIM3v3 for 180 nm process on Tanner EDA?
for Analog IC Design
 

Standard core voltage for a 180nm process is 1.8V. Usable voltage may range from 0.9 to 2.5V, depending on the foundry's specification. It does not depend on any model type nor EDA tool label.
 
ok...Thank you very much for your reply.............can you tell me that I am using PTM 180 nm model, is their any difference in designing parameters while designing Analog amplifier as UMC 180 nm process such as Vth, Un, Cox etc
 

Possibly. But if you can't access the UMC 180nm models, it's still the best what you can do. Or you could try and use the -018 models from a different fab, provided publicly by MOSIS at the bottom of their appropriate MOSIS WAFER ACCEPTANCE TESTS.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…