BMP2PCB giving 1mil tracks.

[mhamza]

I was working on to convert a logo into my altium designer But I am getting a lot of 1mil tracks even after using a 1000dpi image. Can someone suggest how to remove this so that the contents of the layer comes as a whole not in small lines? Thankyou in advance.

 

[KlausST]

Hi,

what do you mean by "even"?
1 mil equals 1000 dpi.

I would not be surprised if a 250 dpi BMP results in 4 mil traces.

Klaus

 

[mhamza]

I was working on to convert a logo into my altium designer But I am getting a lot of 1mil tracks even after using a 1000dpi image. Can someone suggest how to remove this so that the contents of the layer comes as a whole not in small lines? Thankyou in advance.

Hi,

what do you mean by "even"?
1 mil equals 1000 dpi.

I would not be surprised if a 250 dpi BMP results in 4 mil traces.

Klaus

I wanto combine all these traces to form a uniform image instead of multiple lines. How to do that??