Bidirectional motor control without MCU or NE555

Status
Not open for further replies.
J

jmx66

Member level 5
Joined
Nov 16, 2010
Messages
93
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,288
Location
France
Visit site
Activity points
2,045



Hi all,

I found this schematic, and i want to know if there's no mistakes...

In fact, motor current is about 2 A ,so what resistors values for TIP122 - TIP31 become TIP122 - ?

It's for a road book, so no MCU, NE555 ...


Thanks a lot.

jm
 

Thanks a lot for your reply.

For more current if TIP31 replaced by TIP122, resistor values changed?

Thanks a lot.

jm
 


Yes you can .. But you should have a supply of higher current because Tip31 supports 3A flow and Tip122 supports 5A flow ..
 
Reactions: jmx66

    J

    jmx66

    Points: 2
    Helpful Answer Positive Rating
Thanks a lot.

Don't worry about power supply...

Alternator + bridge output of Yam 500XT: so 60 Watt isn't a problem.

Jm
 

Thanks a lot first,

Right for upper transistor, so mistake on this schematic?

For lower 2.2 KOhm and 10 KOhm.


Regards.

jm
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…