Best way to get hysteresis with LM111 comparator?

Status
Not open for further replies.
C

cupoftea

Advanced Member level 6
Joined
Jun 13, 2021
Messages
3,057
Helped
62
Reputation
124
Reaction score
139
Trophy points
63
Activity points
15,948
Hi,
Would you agree, the attached (LTspice and jpeg) is the best way to get hysteresis with an LM111 comparator?
(Hysteresis needed to avoid noise problems, and "chattering".)
...ie, just tie Balance and strobe pins together, and have a positive feedback resistor, as shown?.
(LT1011 is pin for pin compatible with LM111).
 

Attachments

  • LM111.jpg
    106.2 KB · Views: 205
  • LM111.zip
    771 bytes · Views: 159

Sort by date Sort by votes
Hi,

according to the datasheet you can leave the BAL/STROB and BALABCE unconnected, or you can short them together, see Fig. 17. page 15.

Is the 5 V supply the output of a regulator, or is it created by a resistor devider?

BR
 
Upvote 0 Downvote
Thanks, the 5V is the output of an opamp buffer.
The LT1011 datasheet says floating BAL and Strobe can cause noise.....that they should be either shorted together, or connected with a 100n cap.
I wonder if this applies to the LM111?
 
Last edited:

Upvote 0 Downvote
Hi,

I don't undersrand why two different types of comparators are in this discussion.

If you use LT1011 then refer to LT1101 datasheet.
If you use LM111 then refer to LM111 datasheet.
To further increase the confusion, in the schematic it shows "use LM311".

Please explain.

Klaus
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…