Basic rules for Routing in PADSPCB

Status
Not open for further replies.
Hi,
First conform to me, you board is single side or double side. if you board is single side you have to take routing in bottom side only.
you trace width should be 12 mil for single side for double side more than 6mil is better.
for Power (+5v) single side 40 mil,double side 20 mil
 
Hi usha,
i need some clarification in your board from input of image.
1.your board is single side or not ? (if it is single side take trace from bottom only)
suggestion:
trace should not 90 degree,reduce the board size,use trace width minimum 12 mil for normal trace and power better 20 mil or 40 mil depends on amps.
refdes orientation like that only (see image i)

let me know the pad size ?


- - - Updated - - -

hi
check this


- - - Updated - - -

please check image 2
 
hi kapil,

thanks for ur suggestion

the board is single side
i have routed in bottom layer

i have taken the library parts of PADSPCB.not yet created any component

length cannot be changed as it require 95mm where width can be changed
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…