Sancrip
Newbie level 1
Hi,
I’m trying to build a midterm system between a costly and highly custom VPX and a platform where each board interfaces with one another by cables.
for example:
imagine I have an off the shelf mini-itx motherboard, a switch, and 2 network video encoders
my idea is to have a back plane that would supply power, serial communication (if required) and network. I would have to build custom fixtures for each board and cables to interface between the board and the back plane but globally the total number of cables will be reduced.
i have searched the internet for answers, mainly regarding to high speed connector and pcb layout but no answer was found.
Could someone please help me? any input is welcome.
thank you in advance
ps: im not sure if this is the right place to put this post.. feel free to change it
I’m trying to build a midterm system between a costly and highly custom VPX and a platform where each board interfaces with one another by cables.
for example:
imagine I have an off the shelf mini-itx motherboard, a switch, and 2 network video encoders
my idea is to have a back plane that would supply power, serial communication (if required) and network. I would have to build custom fixtures for each board and cables to interface between the board and the back plane but globally the total number of cables will be reduced.
i have searched the internet for answers, mainly regarding to high speed connector and pcb layout but no answer was found.
Could someone please help me? any input is welcome.
thank you in advance
ps: im not sure if this is the right place to put this post.. feel free to change it
Last edited: