Atmega128--------L298 Motor driver problem

Status
Not open for further replies.
K

kunal5959

Junior Member level 3
Joined
Jul 26, 2011
Messages
31
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
1,644
I bought a L298 Motor driver recently and i am trying to run dc motors using ATMEGA128 MCU. I have a strange problem. Before programming and connecting the MCU. I just connected 11v to the Power supply of the driver and measured the signals .. I see that ENA and ENB are both 5v . IN1......IN4 are 2.5v. All pins used for powering MOTORA and MOTORB are 11V i.e. also the pins meant for GND of Motor is high. all jumpers on the PCB are in place.. This means there is a hardware problem according to me..

Can anyone help me in diagnosing the problem.!

Datasheet:-

**broken link removed**
 

Attachments

  • 20141113_123800.jpg
    2.6 MB · Views: 95

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…