K&#305z&#305
Junior Member level 3
- Joined
- May 19, 2010
- Messages
- 27
- Helped
- 1
- Reputation
- 2
- Reaction score
- 0
- Trophy points
- 1,281
- Location
- Ankara / Turkey
- Activity points
- 1,429
Hi, I have designed a quad ridged horn antenna. Everything is fine, gain, sparameters, etc. However, E-plane pattern of each port has shifted 1-2 degrees. It is because of the asymmetry of quad ridged waveguide feed section. This is caused by the phase delay due to other prob's enterance. When I use the connector having small external radius, the shift decreases. However, I should use a specific connector, therefore I need a techniques to get rid of this asymmetry.
Could you give me an advice on this issue?
Regards..
Could you give me an advice on this issue?
Regards..