Astable multivibrator using 555 vs transistors

A

ay215

Newbie
Joined
Sep 13, 2024
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
19
If I'm not mistaken, an astable multivibrator can be built with a 555 ic, or using transistors, capacitors, and resistors. I was wondering if there are any advantages or disadvantages of using one approach over the other? Like cost or effectiveness? Thanks.
 

Sort by date Sort by votes
My observation is that 555 output is designed to make rapid square-ish transitions. It must be a chief factor letting it oscillate near 1/2 MHz or faster. I believe the design of logic IC's is similar: High gain snap-action, good at pulse generating.

The classic astable multivibratpr is not quite so square-ish. However it does give you two alternating clocks, each one's phase inverted from the other. This can be convenient for certain uses.
 

Upvote 0 Downvote
If the 555 astable meets your output design requirements, then it is likely the cheaper, simpler choice.
If not, then you can design one using discrete devices, or logic gates, which would likely be a more complex circuit.
 

Upvote 0 Downvote
Hi,

if I´m not mistaken "logic gates" never are mentioned by the OP.
The question was NE555 vs discrete..

Klaus
 

Upvote 0 Downvote
A 555 will work on dirty cig lighter power all by itself, a transistor bodge likewise unless you pick something too fancy. CD4000 has two subfamilies and one rates at 18V but that's weak for automotive IGN power quality.

You can also make a real sloppy astable with a single Schmitt inverter, or less sloppy with a comparator inverting signal with positive feedback.
 

Upvote 0 Downvote
You must log in or register to reply here.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…