Ask for help about the non-use pins of the MCU chip

Status
Not open for further replies.
B

bhl777

Full Member level 6
Joined
Sep 30, 2008
Messages
363
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
5,140
Hi guys, I am doing a MCU Design then I am drawing the PC Poard for the whole circuit. Someone told me that I should connect the pins which are not used to the GND or VDD. For example, in the 14-pin MSP430 chip, I just use 7 of them and the other 7 pins is not used. Should I let them be float or connect them to the VDD or GND? Thank you for helping me out!
 

just leave them floating

Regards
Nandhu
 

    B

    bhl777

    Points: 2
    Helpful Answer Positive Rating
if you used MSP430 ,just leave them floating
 

    B

    bhl777

    Points: 2
    Helpful Answer Positive Rating
I don't use the MSP430, but would suppose it has internal pull ups, so leaving disconnected would not be a problem. Good general logic practice though is not leave floating pins, inputs in particular.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…