Arduino Connection Problem

 [syntax=c] #include <SIM900.h> [/syntax]

 [syntax=c] #include "SIM900.h" [/syntax]

#include "SIM900.h"
#include "SoftwareSerial.h"
//If not used, is better to exclude the HTTP library,
//for RAM saving.
//If your sketch reboots itself proprably you have finished,
//your memory available.
//#include "inetGSM.h"

//If you want to use the Arduino functions to manage SMS, uncomment the lines below.
#include "sms.h"
SMSGSM sms;

//To change pins for Software Serial, use the two lines in GSM.cpp.

//GSM Shield for Arduino
//www.open-electronics.org
//this code is based on the example of Arduino Labs.

//Simple sketch to send and receive SMS.

int numdata;
boolean started=false;
char smsbuffer[160];
char n[20];

void setup() 
{
  //Serial connection.
  mySerial.begin(9600);
  Serial.begin(9600); //only if USB will be connected
  mySerial.println("AT+IPR=9600"); //sets the GPRS chip to communicate at 9600 as well
  //Start configuration of shield with baudrate.
  //For http uses is raccomanded to use 4800 or slower.
  if (gsm.begin(2400)){
    Serial.println("\nstatus=READY");
    started=true;  
  }
  else Serial.println("\nstatus=IDLE");
  
  if(started){
    //Enable this two lines if you want to send an SMS.
    if (sms.SendSMS("+639062407300", "Arduino SMS"))
      Serial.println("\nSMS sent OK");
  }

};

void loop() 
{
  if(started){
    //Read if there are messages on SIM card and print them.
    if(gsm.readSMS(smsbuffer, 160, n, 20))
    {
      Serial.println(n);
      Serial.println(smsbuffer);
    }
    delay(1000);
  }
};