[SOLVED] antenna matching , s11 always must be 50 ohm?

Status
Not open for further replies.
A

amntt

Advanced Member level 4
Joined
Feb 4, 2013
Messages
119
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Visit site
Activity points
1,868
s11 in designing microstrip antenna always should be 50 ohm? i design an antenna which its s11 is 70 , i change dimansions to have s11=50 but i think its performance and resonance depth was much better when s11 was 70 . we can not design antenna with s11=70?
 

The 50 Ohm value is a standard for tranmission lines. Most sources are 50 Ohms and fo the best results (matching), also antennas should have close to 50 Ohms.
Most antennas are mismatched a bit, so transformers and matching structures (tuners) are used to optimize matching. Read some basic antenna textbook, please.
 

As stated Above, If ur antenna is of 70 ohm impedance, the u need a matching section for match the standard port 50 ohm to ur antenna 70 ohm, for Good design..!!
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…