Munib
Advanced Member level 4
- Joined
- Jun 11, 2004
- Messages
- 114
- Helped
- 3
- Reputation
- 6
- Reaction score
- 3
- Trophy points
- 1,298
- Activity points
- 1,129
I have got RF modules TXM-418-LR and RXM-418-LR
and the antenna ANT-418-PW-RA from LINX technologies.
I want my antenna to be at right angle to the PCB surface for that what i am thinking to do is to have small tab on the PCB very near to the RF module(because as datasheet says if i can place antenna at <1/8 inch to the module then there is no need for microstrip line) and then connect that small tab to my antenna through a small L shaped copper strip so that my antenna connects at right angle to the board surface
Am i right in doing so ? will it work properly?
Any one who has used this antenna?
and the antenna ANT-418-PW-RA from LINX technologies.
I want my antenna to be at right angle to the PCB surface for that what i am thinking to do is to have small tab on the PCB very near to the RF module(because as datasheet says if i can place antenna at <1/8 inch to the module then there is no need for microstrip line) and then connect that small tab to my antenna through a small L shaped copper strip so that my antenna connects at right angle to the board surface
Am i right in doing so ? will it work properly?
Any one who has used this antenna?
