Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Ansys maxwell magnetostatic simulation

Status
Not open for further replies.
O

Oblivion1912

Newbie level 1
Newbie level 1
Joined
Nov 12, 2016
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
12
Hello Everyone,
I'm new in ANSYS MAXWELL and Electromagnetic. Recently I'm curious about modeling a simple generator in this software. I built a model of generator with a simple coil and permanent magnet (PM). I'v chosen Magnetostatic solver for this simulation. I parametricaly moved the PM reciprocally (like a piston) through the coil. I analysed the model by Optimetrics setup. In 0.1 second the PM moves back and force one time. I attached the results.
Here is my question:
1- I want to know does the model include Back-EMF in simulation?
2- If I simulate the generator in Transient mode, the Result will be different or not? (Should I simulate it in Transient mode?)

https://obrazki.elektroda.pl/2616839700_1479018291.png
https://obrazki.elektroda.pl/8389427100_1479018291.png

Thanks in advance.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top