Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

analytical design of Bow-tie

Status
Not open for further replies.

babinton

Member level 4
Member level 4
Joined
Apr 8, 2006
Messages
79
Helped
7
Reputation
14
Reaction score
5
Trophy points
1,288
Location
Nigeria
Activity points
1,959
how to design a bow tie

Hello Everyone,

I need help in designing a bow-tie antenna analytically before confirmation with numerical tools. Please, can any body help me with a book that atleast give an insight on how to go about the design. Thanks, Babinton
 

bow-tie antenna flare length

Bow-tie antennas on a dielectric half-space: Theory and experiment
Compton, R.; McPhedran, R.; Popovic, Z.; Rebeiz, G.; Tong, P.; Rutledge, D.;
Antennas and Propagation, IEEE Transactions on [legacy, pre - 1988]
Volume 35, Issue 6, Jun 1987 Page(s):622 - 631

pl
 

antenna impedance bowtie

Thanks fr your reply,
I have a problem, I don't know how I can get the paper, please can you upload it .
Babinton
 

bowtie antenna gpr book

Dear babinton,

Here's the paper.

However, based on my own experience in playing around with bow-ties, it is rather difficult to analyse it. Cos' it is rather broadband (which means you cannot easily identify any fundamental modes of excitation), and its frequency response is also governed by its flare angle (I remembered making the same comment about bow-tie antennas in another thread, search for it). Anyway, hope the paper helped.

Best regards,
Dave
 
bow-tie antenna impedance

Thanks,
Please, what advice can you give me on another antenna that I can use for the ground penetrating radar system .

Regards
Babinton
 

flare angle antenna bow tie

Antennas for GPR:
1. Bowtie
2. Dipole --> more difficult for matching impedance
3. Horn
4. ...else...?
 

bowtie antenna impedance

i needed it for my thesis. i have to simulate it with HFSS. thanks
 

designing a bow

does anyone here know
what is the input impedance for a bow-tie dipole antenna????
 

andrian andaya lestari

I'm having the same problem... I am performing simulations too, but I am unable to reproduce the results that I have found on the attached paper. See figure 6 and the explanation on page 422. They say that the impedance is real for any bow angle.

Alessandro
 
bowtie dipole impedance matching

ayy2023 said:
does anyone here know
what is the input impedance for a bow-tie dipole antenna????

Its depend on the flare-angle...

**broken link removed**

source: Lestari, Andrian Andaya. Antennas For Improved Ground Penetrating Radar. IRCTR, TU Delf, 2003

monfardi said:
They say that the impedance is real for any bow angle.

Bowtie antenna impedance is only real when it have infinite length
see: Lestari, Andrian Andaya. Antennas For Improved Ground Penetrating Radar. IRCTR, TU Delf, 2003.


Br,
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top