Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Analog Interface units for PLC /automat controls

Status
Not open for further replies.
V

vimalkhanna

Full Member level 6
Full Member level 6
Joined
Aug 7, 2010
Messages
322
Helped
55
Reputation
110
Reaction score
53
Trophy points
1,308
Location
delhi
Activity points
3,224
I need to design Analog 0-2.5VDC //0-1VDC input to 4-20mA digital/analog control for PLC feedback.
Conveyance thru RS232 /485 reqts are a must since the sensor and control are more than 100mtrs away.
Data display of blind /set values also needed.
 

What is the PLC device you use.
Can you draw a simple block diagram of that system you are designing.

Regards KAK
 

Will get back to you with a sketch of the required version.The sensor and control are in a different room(supervisors)and the PLC(national ) is on the automat .which is in the workshop.
The managers room is needing an overall inndication of the effected control signal.
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top