Altium pcb component issue

Status
Not open for further replies.
E

engineer1000

Advanced Member level 4
Joined
Aug 16, 2012
Messages
106
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Visit site
Activity points
2,060
I have created a new component , a 5 pin connector. Its in the schematic and transferred across to the pcb.
When I click on it and try to move it my whole board disappears, I then have to view document again to see it.
Really puzzled as to why it's doing it . Can anyone suggest anything?
 

I assume in the library you have not set the "Set Reference Point" to the Center of the component. So every time you try to grab the component, your mouse will go to a far point, beyond the boundary of your PCB. The "Set Reference Point" can be found in library mode (where you can edit the component) in the Edit->Reference.
 
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…