carpenter
Full Member level 6
Hello in lasdt AD 22.2.1 I want to cut a slot.
Create Mechnical Layer 16 , Layer Type set to Route tool Path.
And in Layer 16 Place line
Result milled section through PCB (on picture in left), but if I have copper spilled on the PCB like Polygon plane, the result is the picture on the right.
Where is the problem, am I doing something wrong or is it an AD error?
Create Mechnical Layer 16 , Layer Type set to Route tool Path.
And in Layer 16 Place line
Result milled section through PCB (on picture in left), but if I have copper spilled on the PCB like Polygon plane, the result is the picture on the right.
Where is the problem, am I doing something wrong or is it an AD error?
